Jessberger Drum Pump Set JP-380 for Aggressive Chemicals

Drum Pump Set with an electric motor for highly aggressive liquids such as concentrated acids and alkalis

The JP-380 Drum pump set is a preassembled drum pump set for 200L drums (immersion length 1000 mm) or IBCs (immersion length 1200 mm). The JP-380 drum and IBC pump is suitable for highly concentrated and aggressive acids and alkalis. 

This pre-assembled drum pump set is a complete plug-and-play kit where everything you need to get started is included in the package. Simply unpack, install and turn the power on and you are ready to use your new electrical drum pump.

The drum pump motor is characterized not only by its light weight (3,6 kg) but also by its elegant and ergonomic design and ease of use. The non-stationary and stationary usable drive is particularly suitable for intermittent operation. The internally ventilated motor provides optimal air cooling, and a low noise level and ensures high operational safety and long durability.

The motor housing made of polypropylene ensures high chemical resistance when aggressive vapors of acids and alkalis are present. With an IP55 Class this housing is protected from limited dust ingress and from low pressure water jets from any direction.

The pump tube is made of Polyvinylidenfluorid (PVDF). These tubes are suitable for neutral and hardly combustible liquids. With these pump tubes particularly highly aggressive liquids such as concentrated acids and alkalis up to a maximum viscosity of 1.000 mPas will be transferred with ease.

Drive shaft: Hastelloy 2.4610

Media temperature: max. 90°C

On the drum pump housing, an integrated low voltage release on/off switch is installed. This switch is intended to prevent an uncontrolled start of the drum pump motor after a power failure or voltage drop and thus guarantees maximum safety. 

The Jessberger drum pumps operate on the principle of the axial-impeller pumps. The pump unit consists of a drive motor and pump. The motor drives the drive shaft via a coupling. At the end of the drive shaft, there is a propeller-like pump impeller (rotor). The rotor must be completely covered with the medium so that the pump can work. With the rotation, the medium is axially transferred to the outlet, i.e. parallel to the pump shaft.

Each of our drum pump sets consists of an electric drum pump motor, a pump tube suitable for the application, a two-meter media-proof dispensing hose, and a nozzle, which facilitates filling and transferring.

Drum & IBC pump media examples:

• Formic acid (50%)
• Ammonia
• Boric acid
• Distilled water
• Liquid fertilizers
• Iron-II and III-chloride
• Acetic acid (80%)
• Photo developers
• Fruit acids
• Potassium hydroxide
• Copper chloride
• Lactic acid
• Sodium hydroxide
• Phosphoric acid
• Hydrochloric acid
• Sulfuric acid (up to 90%)
• Hydrogen peroxide
• Citric acid
• Hydrobromic acid
• Chloric acid
• Chromic acid
• Hydrofluoric acid
• Sodium hypochlorite
• Nitric acid

Suitable for:

• Chemistry
• Water treatment
• Agriculture
• Petro Chemistry
• Surface technology
• Other industries

Technical data:

JP-380 PVDF Universal motor 230 V, 50 Hz, 825 W, IP 55, protection class I, on/off switch, with low voltage release, 5 m cable with plug.

Pump tube:

• PVDF outer-Ø 41 mm, HC-shaft 2,4610
• Connection thread G 1¼”
• Hose connection 1″ (DN 25)
• 2 m Multi purpose hose 1″ (DN 25)
• 2 Hose clamps stainless steel
• 1 Nozzle PVDF 1″