Jessberger Drum Pump Set JP-280 for Mineral Oil Products

Drum Pump Set with an electric motor for mineral oil substances

The JP-280 Drum pump set is a preassembled drum pump set for 200L drums (immersion length 1000 mm) or IBCs (immersion length 1200 mm). The JP-280 drum and IBC pump is suitable for neutral, aggressive, and hardly combustible liquids. With the aluminum tube, this drum pump can be used for pumping neutral and flame-retardant media and especially mineral oil products.

Together with the JP-180 drum pump, this JP-280 is our top seller drum pump.

This pre-assembled drum pump set is a complete plug-and-play kit where everything you need to get started is included in the package. Simply unpack, install and turn the power on and you are ready to use your new electrical drum pump.

The drum pump motor is characterized not only by its light weight (3,8 kg) but also by its elegant and ergonomic design and ease of use. The non-stationary and stationary usable drive is particularly suitable for intermittent operation. The internally ventilated motor provides optimal air cooling, and a low noise level and ensures high operational safety and long durability.

The motor housing made of polypropylene ensures high chemical resistance when aggressive vapors of acids and alkalis are present.

The pump tube is made of Aluminum (ALU). These tubes are suitable for neutral and hardly combustible liquids. With these pump tubes particularly mineral oil products up to a maximum viscosity of 1.000 mPas will be transferred with ease.

Drive shaft: Stainless steel 316Ti

Media temperature: max. 90°C

On the drum pump housing, an integrated low voltage release on/off switch is installed. This switch is intended to prevent an uncontrolled start of the drum pump motor after a power failure or voltage drop and thus guarantees maximum safety. 

The Jessberger drum pumps operate on the principle of the axial-impeller pumps. The pump unit consists of a drive motor and pump. The motor drives the drive shaft via a coupling. At the end of the drive shaft, there is a propeller-like pump impeller (rotor). The rotor must be completely covered with the medium so that the pump can work. With the rotation, the medium is axially transferred to the outlet, i.e. parallel to the pump shaft.

Each of our drum pump sets consists of an electric drum pump motor, a pump tube suitable for the application, a two-meter media-proof dispensing hose, and a nozzle, which facilitates filling and transferring.

Drum & IBC pump media examples:

• Drilling emulsions
• Diesel
• Liquid soap
• Liquid wax
• Gear oils
• Heating oil
• Hydraulic oils
• Machine oils
• Mineral oils 
• Motor oils

Suitable for:

• Chemistry
• Water treatment
• Agriculture
• Petro Chemistry
• Surface technology
• Other industries

Technical data:

JP-280 ALU Universal motor 230 or 115 V, 50/60 Hz, 825 W, splash protection to IP 24, double insulated class II, over load protection switch with low voltage release, 5 m cable with plug

Pump tube:

• Aluminium, outer-Ø 41 mm, shaft stainless steel
• Connection thread G 1¼”
• Hose connection 1″ (DN 25)
• 2 m Mineral oil hose 1″ (DN 25)
• 2 Hose clamps stainless steel
• 1 Nozzle aluminium 1″